Test-A: Oxygen Sensor in front of Catalytic Converter Bank 2 - Sensor 1
WARNING: This page is about a different variant/trim than selected.
- Connect the scan tool.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Test-ID 02 ($02)".
- Select the desired "Test-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 129 ($81) | Oxygen sensor current value. | 0.9212 | 1.0781 | ||
| 130 ($82) | Control threshold. | 0.9212 | 1.0781 | ||
| 131 ($83) | P0153 | Dynamic value. Dynamic test reduced threshold. | 0.9961 | 4.0039 | Refer to P0153 under Test-A: Oxygen Sensor in front of Catalytic Converter Bank 2 - Sensor 1 . |
| 132 ($84) | Delta offset through LRHK. | -0.0309 | 0.0309 |
- If any component or system fails to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
End of diagnosis.