Diagnostic Mode 07: Check Test Results of Components that are Continuously Monitored
WARNING: This page is about a different variant/trim than selected.
Diagnostic Mode 07 displays all stored DTCs of emission related components and systems which are continuously monitored.
NOTE:
- Depending on scan tool and protocol used, diagnostic mode 07 and the information provided may be referred to by a different name.
Procedure
- Connect the scan tool.
- Start the engine and run at idle.
- Select "Mode 7: Check test results of components that are continuously monitored".
The number of stored DTCs or "0 malfunctions detected" will be displayed scan tool screen.
- Switch the ignition off.
- Refer to the following DTC tables for the diagnostic repair procedure:
- SAE P0xxxDTCs. → SAE P0xxx DTCs .
- SAE P1xxxDTCs → SAE P1xxx DTCs .
- SAE P2xxxDTCs. → SAE P2xxx DTCs .
- SAE P3xxxDTCs. → SAE P3xxx DTCs .
- SAE U0xxxDTCs → SAE U0xxx DTCs .
- Switch the ignition off.
End of procedure