Diagnostic Mode 01: Obtain Data
WARNING: This page is about a different variant/trim than selected.
Diagnostic Mode 01 is used to display and monitor all emissions related measured values.
Test requirement
- Coolant temperature at least 80°C.
Procedure
- Connect the scan tool.
- Start the engine and run at idle.
- Select "Diagnostic Mode 1: Obtain data.".
- From the following table, select the desired the "PID" that is to be monitored, e.g. "PID 05 - Coolant temperature".
NOTE:
- More than one "PID" may be selected and monitored.
The current values of the component or system that is being monitored will be displayed on the scan tool screen.
| PID | Component or System |
|---|---|
| 04: | Calculated load value |
| 05: | Coolant temperature |
| 06: | Oxygen integrator, bank 1 |
| 07: | Oxygen adaptation value, bank 1 |
| 08: | Oxygen integrator, bank 2 |
| 09: | Oxygen adaptation value, bank 2 |
| 12: | Engine RPM |
| 13: | Vehicle speed |
| 14: | Ignition timing adjustment at 1. cyl. in direction |
| 15: | Intake air temperature (IAT) |
| 16: | Air flow quantity at Mass Air Flow (MAF) sensor |
| 17: | Throttle valve position (absolute) |
| 18: | Secondary air injection (AIR) |
| 19: | Oxygen sensor location |
| 21: | Sensor voltage Bank 1 Sensor 2 |
| 25: | Sensor voltage Bank 2 Sensor 2 |
| 28: | OBD request is designed for diagnostic of this vehicle |
| 33: | Driven distance after MIL on |
| 52: | Oxygen sensor value Bank 1 Sensor 1 |
| 56: | Oxygen sensor value Bank 2- sensor 1 |
- Switch the ignition off.
End of procedure