Diagnostic Mode 07: Check Test Results of Components that are Continuously Monitored

WARNING: This page is about a different car, the 2006 Audi TT, 2005 Audi TT, and 2004 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostic Mode 07 displays all stored DTCs of emission related components and systems which are continuously monitored.

NOTE:

Depending on scan tool and protocol used, diagnostic mode 07 and the information provided may be referred to by a different name.

Procedure

Connect the scan tool.
Start the engine and run at idle.
Select "Mode 7: Check test results of components that are continuously monitored".

The number of stored DTCs or "0 malfunctions detected" will be displayed scan tool screen.

Switch the ignition off.
Refer to the following DTC tables for the diagnostic repair procedure:

SAE P0xxxDTCs. → SAE P0xxx DTCs .
SAE P1xxxDTCs → SAE P1xxx DTCs .
SAE P2xxxDTCs. → SAE P2xxx DTCs .
SAE P3xxxDTCs. → SAE P3xxx DTCs .

SAE U0xxxDTCs → SAE U0xxx DTCs .

Switch the ignition off.

End of procedure