Step 3: Adaptation of throttle valve control module to ECM

Indicated on display

Fig 1: VAG Scan Tool Display - Adaptation Of Throttle Valve Control Module To ECM (1 Of 4)

• Press buttons -0- and -8- to select "Read Measuring Value Block" function 08, and press -Q- button to confirm input.

Indicated on display

Fig 2: VAG Scan Tool Display - Adaptation Of Throttle Valve Control Module To ECM (2 Of 4)

• Press buttons -0-, -6- and -0- to input display group number 60 (060), and press -Q- button to confirm input.

Indicated on display (1 -4 = display fields)

Fig 3: VAG Scan Tool Display - Adaptation Of Throttle Valve Control Module To ECM (3 Of 4)

• Press button -4- to select "Basic Setting" function 04 (adaptation of throttle valve control module to ECM)

Indicated on display (1 -4 = display fields)

Fig 4: VAG Scan Tool Display - Adaptation Of Throttle Valve Control Module To ECM (4 Of 4)

• Check specified values in display fields 3 and 4:
  DISPLAY GROUP 60: ADAPTATION OF THROTTLE VALVE CONTROL MODULE TO ENGINE CONTROL MODULE (ECM)
  
  

  	Display fields
  	1	2	3	4
  Display group 60: Adaptation of throttle valve control module to Engine Control Module (ECM)
  Display	xxx ANGLE °	xxx ANGLE °	Idle	ADP.runs
  			Part Throt	ADP. OK
  			Full Throt	ADP.ERROR
  			Decel
  			Enrich
  Indicated	Throttle valve angle	Throttle drive angle	Operating condition	Adaptation status
  Specified value	---	---	Idle	ADP. OK

If "ADP. ERROR" is indicated in display field 4:

• Check DTC memory. See CHECK DTC MEMORY (SCAN TOOL FUNCTION 02) .

If the specified value "ADP. OK" is indicated in display field 4:

• Press --> button.