DTC table

Observe test conditions, see TEST CONDITIONS .
Connect VAS5051 tester or VAG1551 scan tool and select the address word 03 "Brake Electronics". See VAG1551 SCAN TOOL (ST), CONNECTING AND ENTERING ADDRESS WORD .
Check the control module version. See CONTROL MODULE VERSIONS (SCAN TOOL FUNCTION 01), CHECKING and press --> button.
Press buttons -0- and -2- to select "Check DTC Memory" function 02. Press -Q- button to confirm input.
Every malfunction that the system can detect has a 5-digit Diagnostic Trouble Code (DTC), which is listed in the left-hand column of the DTC table. If the printer is switched on by pressing the "PRINT" button, the VAG1551 scan tool (ST) prints out a message identifying the malfunction and the DTC. Otherwise, DTCs are not displayed by the VAG1551 scan tool.
The contents of the DTC memory remain stored until the memory is erased. See ERASE DTC MEMORY .
Sporadic malfunctions (see ON BOARD DIAGNOSTIC (OBD) ) are identified by "ISP" appearing on the right-hand side of the display.
Static malfunctions that cannot be detected when the vehicle is stationary are also identified with "ISP" if the ignition has been switched off and then on again.
The following DTC table includes all the DTCs that can be stored by the ABS Control Module (w/EDL) -J104- and displayed and printed out by the VAS5051 tester or VAG1551 scan tool. Malfunctions are listed according to the DTC number.