LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 1991 >> 200 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Controls - System/Component Tests) >> Fuel System >> Fuel Pressure Release

Fuel Pressure Release

WARNING: This page is about a different car, the 1993 Audi 90 and 1993 Audi 100. However, it is still accessible from the selected car via links, so may be relevant.

Remove fuel pump relay. See ELECTRICAL COMPONENT LOCATIONS  table. Start engine. Allow engine to run until it stops. Turn ignition off. Disconnect negative battery cable. Slight pressure may remain in system. Before disconnecting any fuel system line, cover connector with a clean shop towel. Install fuel pump relay.

scientia non olet · About LEMON Manuals