LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 1991 >> 200 Base >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Throttle Body >> Removal & Installation

Removal & Installation

  1. Disconnect accelerator cable from linkage. Disconnect vacuum hoses, return spring and cruise control connecting rod (if equipped). Remove throttle body mounting nuts.
  2. Disconnect fuel return hose from pressure regulator. Lift sensor housing upward and remove throttle body. Remove gasket.
  3. To install, reverse removal procedure. Ensure all surfaces are clean and mate correctly. Use new gaskets. See TORQUE SPECIFICATIONS table at the end of article.
scientia non olet · About LEMON Manuals