LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 1990 >> 200 Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Engine Sensors & Switches >> Cis-E III >> Idle Switch

Idle Switch

  1. Connect voltmeter between Test Adapter (VW 1501) connector 1 and ground. See Figure . Voltmeter should read battery voltage. Turn ignition off.
  2. Move throttle valve .20-.28" (.5-.7 mm). With feeler gauge between throttle valve stop and adjustment screw, measure resistance between test adapter connector 1 and ground using ohmmeter. Resistance should change from zero ohm (with throttle closed) to infinity as throttle gap increases beyond .020" (.5 mm).
  3. If resistance is not as specified, adjust idle gap to .006-.020" (.15-.5 mm). See Fig 1 . If resistance is as specified, check full throttle switch.
Fig 1: Adjusting Idle Switch Idle Gap
G94353Courtesy of AUDI OF AMERICA, INC.
scientia non olet · About LEMON Manuals