LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 1990 >> 200 Base, Automatic >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> Anti-Lock Brake System >> Removal & Installation >> Front Speed Sensor >> Removal & Installation

Removal & Installation

  1. Remove speed sensor retaining bolt. Pull speed sensor out of wheel bearing housing. Remove wiring harness from body, and unplug from nearest connector. One connector is located behind windshield washer reservoir.
  2. To install, reverse removal procedure. Install new "O" ring and plastic tip on sensor. Tip ensures proper air gap between sensor and rotor. Install sensor in housing until plastic tip touches rotor.
  3. Install and tighten retaining bolt to 86 INCH lbs. (10 N.m). Install rubber grommets in retainers on wheel bearing housing. Fasten wiring harness clips to body. Plug in speed sensor connector.
scientia non olet · About LEMON Manuals