All Models

Before checking toe-in, check wheel rim runout and replace rim if necessary. If toe-in is not to specifications, adjust by loosening tie rod outer locking nut and clamp and turning tie rods until correct toe-in is obtained. Tighten lock nut and clamp and recheck toe-in.

WHEEL ALIGNMENT SPECIFICATIONS

Application

Caster (Degrees)

Camber (Degrees)

Toe-In (Inches)

Toe-Out On Turns (Degrees)

Inner

Outer

Fox

1/2 ± 1/2

1/2 ± 1/3

0 to 5/64

.....

Model 100

⁽¹⁾0 ± 1/4

0 ± 1/2

3/64 to 1/8

.....

⁽¹⁾	With power steering set to - 1/2 ± 1/4 °