All Models
Before checking toe-in, check wheel rim runout and replace rim if necessary. If toe-in is not to specifications, adjust by loosening tie rod outer locking nut and clamp and turning tie rods until correct toe-in is obtained. Tighten lock nut and clamp and recheck toe-in.
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Caster (Degrees) | Camber (Degrees) | Toe-In (Inches) | Toe-Out On Turns (Degrees) | |
|---|---|---|---|---|---|
| Inner | Outer | ||||
| Fox | 1/2±1/2 | 1/2±1/3 | 0 to 1/3 | ..... | ..... |
| Model 100 | 1/10±1/3 | 1/6±1/3 | 0 to 1/3 | ..... | ..... |