Removal And Installation: Removal

NOTE:

If replacing the steering box with integrated power steering control module, use a diagnostic scan tool to perform the flash programming procedure (if available).

NOTE:

If replacing the steering box with integrated power steering control module, connect the diagnosis equipment to the car's diagnostic socket, select "Functions to be used only with FCA Technical supervision" then select the "Reset steering angle sensor offset routine" procedure, carefully following the instructions provided by the diagnosis equipment.

Remove the front suspension crossmember. Refer to CROSSMEMBER, FRONT SUSPENSION, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Remove the steering gear wire harness bracket bolts (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the steering gear wire harness bracket bolt (1).

Courtesy of CHRYSLER GROUP, LLC
Release the retaining clip (1a) and position the wire harness aside (1b).

Courtesy of CHRYSLER GROUP, LLC
Disconnect the two steering gear wire harness connectors (1a) and remove the wire harness (1b).

Courtesy of CHRYSLER GROUP, LLC
Never disconnect the wire harness connectors (a) and (b).

Courtesy of CHRYSLER GROUP, LLC
Remove the steering gear to crossmember bolt (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the steering gear to crossmember bolt (1a).
Remove the steering gear (1b).