TP Sensor Circuit Inspection
NOTICE:
Before disconnecting the PCM connector, jump the SCS line with the HDS, and wait more than 1 minute.
Preconditions
NOTE: This procedure can be done before any other inspections are completed because this test procedure includes all of the following inspection items. However, if this test fails, it will be necessary to continue with each inspection item individually to determine which item failed.
- External circuit is normal
Test Procedure
- Preparation
-
- -
PCM connector E (80P): disconnected
- -
- Procedure
-
- -
Perform the inspection according to the following table.
- -
(Disconnected) PCM connector E (80P) - Refer to: PCM Connector for Inputs and Outputs (1.5L Engine) or PCM Connector for Inputs and Outputs (2.0L Engine) (2024 2025) female terminals
IG Mode
Normal Conditions
Throttle body internal circuit inspection
OFF
There is no continuity
Results
- If it is abnormal, there is a problem with the throttle body.