VCC6 Open Wire Inspection

NOTICE: 

Before disconnecting the PCM connector, jump the SCS line with the HDS, and wait more than 1 minute.

Test Procedure 

• Preparation
• • -

    Brake booster pressure sensor connector (3P): disconnected

  • -

    PCM connector E (80P): disconnected

• Procedure
• • -

    Perform the inspection according to the following table.

(Disconnected)Brake booster pressure sensor connector (3P)female terminals

(Disconnected)PCM connector E (80P) - Refer to: PCM Connector for Inputs and Outputs (1.5L Engine) or PCM Connector for Inputs and Outputs (2.0L Engine) (2024 2025) female terminals

IG Mode

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

Normal Conditions

VCC6 open wire inspection 

OFF

There is less than 1 Ohm 

Results 

• If abnormal, there is a problem in the circuit.