Brake Booster Pressure Sensor Inspection

NOTE:  Since there is no direct method to test the component itself, troubleshooting is performed on the related components.

Test Procedure 

• Preparation
• • -

    Brake booster pressure sensor connector (3P): disconnected

• Procedure
• • -

    Perform the inspection according to the following table.

(Disconnected)Brake booster pressure sensor connector (3P)female terminals

IG Mode

Courtesy of HONDA, U.S.A., INC.

Normal Conditions

Unit output voltage inspection 

ON

About 5.0 V 

Results 

• If it is normal, there is a problem with the brake booster pressure sensor.
• If it is abnormal, there is a problem with other related components.