Auto High-Beam (High-Beam Support System) Function Test (Integrated Driver Support System (Camera and Five Radars)) (2025)

1. Turn the vehicle to the ON mode and confirm there are no auto high-beam messages on the multi-information display (MID). If a message is present, check for DTC's and troubleshoot them first before doing this test. Refer to the How to Troubleshoot the Auto High-Beam (High-Beam Support System) - Refer to: How to Troubleshoot the Auto High-Beam (High-Beam Support System) (Integrated Driver Support System) (2025) or How to Troubleshoot the Driving Support (Integrated Driver Support System (Camera and Five Radars)) (2025) or How to Troubleshoot the Auto High-Beam (High-Beam Support System) (Integrated Driver Support System (Camera and Five Radars)) (2025) .

Courtesy of HONDA, U.S.A., INC.

Auto high-beam problem. Manual controls available. See your dealer.

Cover the following areas with masking tape:

Multipurpose Camera (opening on the front windshield) 

Courtesy of HONDA, U.S.A., INC.

Automatic Lighting Control Unit-Sensor / Sunlight Sensor (entire sensor) 

Courtesy of HONDA, U.S.A., INC.

Automatic Lighting / Rain Sensor (opening on the front windshield) 

Courtesy of HONDA, U.S.A., INC.

3. Set the headlight switch to the low beam and AUTO positions.

4. Start the engine and confirm that the headlight low beam is on. Check the gauge control assembly.

• If the auto high-beam activation indicator is on, the system is normal and the test is complete.
• If the auto high-beam activation indicator is off, pull back the headlight switch lever back for at least 30 seconds until the auto high-beam activation indicator blinks once. If it blinks, repeat steps 1

Courtesy of HONDA, U.S.A., INC.