Keyless Access System Symptom Troubleshooting - Immobilizer/Security Indicator Blinks: Inspection

Keyless Access System Inspection 1 

Test Procedure 

• Procedure
• • Do the HDS [SYSTEM CHECK 1] and [SYSTEM CHECK 2].

• Normal Conditions
• • N-1 is indicated.

Results 

• If it is abnormal, troubleshoot the keyless access system according to the result of the SYSTEM CHECK 1 and 2 - Refer to: Keyless Access System Status Log  or Keyless Access System Check .

Keyless Access System Inspection 2 

Test Procedure 

• Procedure
• • With driver's power window open.
  • Turn the vehicle to the OFF (LOCK) mode.
  • Remove all the keyless remotes from inside the vehicle. Place the keyless remotes more than 20 cm (8.0 in) away from the vehicle.
  • Press the engine start/stop switch.
  • Put the keyless remotes into the vehicle to the all doors and trunk lid closed.
  • Touch the engine start/stop switch with the keyless remote. The buttons on the keyless remote should be facing you.
  • Turn the vehicle to the ON mode.
  • Do the HDS [System Check].

• Normal Conditions
• • N-1 is indicated.

Results 

• If it is abnormal, troubleshoot the keyless access system according to the result of the SYSTEM CHECK - Refer to: Keyless Access System Status Log  or Keyless Access System Check .

Gauge Control Module Inspection 

• Keyless Access System inspection 1 is normal
• Keyless Access System inspection 2 is normal

Test Procedure 

• Procedure
• • Do the HDS [Function Test].

• Normal Conditions
• • The immobilizer/security indicator blinks at the same cycles as the other indicators.

Results 

• If it is normal, there is a problem with other related components.
• If it is abnormal, there is a problem with the gauge control module.

Fuel and Emissions Systems Inspection 

Test Procedure 

• If the other inspection item(s) indicated a normal condition, then it is determined that the remaining fuel and emissions systems is the cause.

Results 

• There is a problem with the fuel and emissions systems.