ECT Sensor 1 Inspection
NOTE:
Since there is no direct method to test the component itself, troubleshooting is performed on the related components.
Test Procedure
PCM output voltage inspection
- Preparation
- ECT sensor 1 connector 2P: disconnected
- Procedure
- Turn the vehicle to the ON mode.
- Confirm the HDS [ ECT Sensor 1 Voltage ].
- Normal Conditions
- HDS [ ECT Sensor 1 Voltage ] value is more than 0.08 V .
Results
- If it is normal, there is a problem with ECT sensor 1.
- If it is abnormal, there is a problem with the related components.