Air Fuel Ratio (A/F) Sensor Monitor and Readiness Code

NOTE: 

• During the procedure, do not select the ACC or the OFF mode.
• All readiness codes are cleared when the battery is disconnected, if DTCs have been cleared, or if the PCM is reset with the HDS.

Enable Criteria 

ECT SENSOR 1 at 140 deg.F (60 deg.C) or more.

Procedure 

1. Start the engine.

2. Test-drive the vehicle under stop-and-go conditions with short periods of steady cruise. During the drive, decelerate (with the throttle fully closed) for 5 seconds. After about 3.5 miles (5.6 km), the readiness code should switch from incomplete to complete.Check the readiness codes screen for the AIR FUEL RATIO (A/F) SENSOR in the DTCs MENU with the HDS.

• If the HDS indicates complete, readiness is complete.
• If the HDS indicates not complete, go to the next step.

4. Check for a Pending DTC. If there is no DTC, the enable criteria was probably not met. Select the DATA LIST Menu. Check ECT SENSOR 1 in the ALL DATA LIST with the HDS. If ECT SENSOR 1 is less than 140 deg.F(60 deg.C), run the engine until it is more than 140 deg.F(60 deg.C), then repeat the procedure.