DTC 1701 : R-Camera Error

NOTE: 

• Check the vehicle 12 volt battery condition first - Refer to: 12 Volt Battery Test, or 12 Volt Battery Test (With SH-AWD) .
• This navigation DTC sets when a problem is detected in the rearview camera circuit.
• Check any official Honda service website for more service information about the navigation system.
• Before you troubleshoot, make sure to follow the General Troubleshooting Information - Refer to: How to Troubleshoot the Navigation System (Without Auto Idle Stop System), or How to Troubleshoot the Navigation System (With Auto Idle Stop System), or How to Troubleshoot the Navigation System (2018-19) .

1. Problem verification

   -1. Clear the hard error codes.

   - 2. Turn the vehicle to the OFF (LOCK) mode then the ON mode.

   - 3. Shift the transmission to R position/mode, then shift to P position/mode.

   - 4. Check for hard error codes.

   Is DTC 1701 indicated?

   YES 

   The failure is duplicated, go to step 2.

   NO 

   Intermittent failure, the system is OK at this time.

2. DTC check

   -1. Check for hard error codes.

   Is DTC 2608 indicated?

   YES 

   Go to DTC 2608 troubleshooting - Refer to: Audio-Navigation System DTC Troubleshooting: 2608,  or Audio-Navigation System DTC Troubleshooting: 2608 (2019) .

   NO 

   Replace the audio-navigation unit .