DTC P0106: MAP Sensor Range/Performance Problem (V6)
NOTE: Before you troubleshoot, review the general troubleshooting information - Refer to: How to Troubleshoot the Dual Clutch Transmission (DCT), or How to Troubleshoot the Brake Booster Pressure Monitoring System (With Auto Idle Stop System), or How to Troubleshoot the Fuel and Emissions Systems (V6, Without Auto Idle Stop System), or How to Troubleshoot the Fuel and Emissions Systems (V6, With Auto Idle Stop System) .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0106 MAP Sensor Range/Performance Problem |
DTC (PGM-FI)
- Parts condition check
-1. Check for poor connections or damage to these parts:
- PCV hose
- Purge (PCS) line
- Air cleaner
- Intake air duct
- Intake manifold
- Throttle body
Are the parts OK?
YES
Go to step 2.
NO
Repair or replace the damaged part (s).
- MAP sensor visual check
-1. Remove the MAP sensor.
- 2. Check the MAP sensor port for clogging or restrictions (foreign material, carbon or sludge, etc).
Is the MAP sensor port clogged or restricted?
YES
Remove the clog or restriction from the MAP sensor.
NO
Reinstall the MAP sensor - Refer to: MAP Sensor Removal and Installation (V6), then go to step 3.
- Problem verification 1
-1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Turn the vehicle to the OFF (LOCK) mode.
- 4. Turn the vehicle to the ON mode.
- 5. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P0106 MAP Sensor Range/Performance Problem Is DTC P0106 indicated?
YES
Replace the MAP sensor - Refer to: MAP Sensor Removal and Installation (V6), .
NO
Go to step 4.
- Problem verification 2
-1. Start the engine.
- 2. Hold the engine speed at 3, 000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.
- 3. Test-drive under these conditions:
- Engine coolant temperature (ECT SENSOR 1) above 158 °F (70 °C)
- Transmission in D
- Vary the engine speed between 1, 000-5, 500 rpm, and drive the vehicle at around 40 mph (60 km/h) for 5 seconds
Signal Current conditions Values Unit ECT SENSOR 1 ENGINE SPEED VEHICLE SPEED - 4. Monitor the OBD STATUS for DTC P0106 in the DTCs MENU with the HDS.
DTC Description OBD STATUS P0106 MAP Sensor Range/Performance Problem DTC (PGM-FI)
Does the HDS indicate FAILED?
YES
Replace the MAP sensor - Refer to: MAP Sensor Removal and Installation (V6), .
NO
If the HDS indicates PASSED, intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot. If the HDS indicates NOT COMPLETED, go to step 4-3 and recheck.