System Check and Status Log
NOTE: The HDS can be used to:
- Check the state of the keyless remote registration and the S-NET line by doing a SYSTEM CHECK .
- Check the number of times the keyless access/TPMS control unit or the backup control unit did not permit the engine to start by checking the STATUS LOG .
1. Connect the HDS to the data link connector (DLC), then turn the vehicle to the ON mode and follow the prompts to the SYSTEM SELECTION MENU.
NOTE: If the HDS does not communicate with the vehicle, go to the DLC circuit troubleshooting - Refer to: DLC Circuit Troubleshooting (L4) (2015-17), or DLC Circuit Troubleshooting (V6, Without CAN gateway) (2015-17), or DLC Circuit Troubleshooting (V6, Without SH-AWD, With CAN gateway) (2015-17), or DLC Circuit Troubleshooting (V6, With SH-AWD and CAN gateway) (2015-17), or DLC Circuit Troubleshooting (L4) (2018-19), or DLC Circuit Troubleshooting (V6, Without SH-AWD) (2018-19), or DLC Circuit Troubleshooting (V6, With SH-AWD) (2018-19) .
2. At SYSTEM SELECTION MENU, enter ONE-PUSH START, then select KEYLESS ACCESS CONTROL UNIT or BACKUP CONTROL UNIT.
3. At KEYLESS ACCESS CONTROL UNIT, enter KEYLESS ACCESS SYSTEM INFORMATION, then select SYSTEM CHECK 1 or SYSTEM CHECK 2.
4. At BACKUP CONTROL UNIT, enter SYSTEM INFORMATION, then select SYSTEM CHECK.
5. Do the SYSTEM CHECK. If there is a system check number, do the troubleshooting for the item indicated.
6. Check the STATUS LOG using the HDS . Troubleshoot the line with the highest counts first. If all the lines are 0 (zero), the problem may not be caused by the immobilizer system or keyless access system, check for ignition or fuel problems.
NOTE: Once repaired, clear the status log by removing the No. A29 (10 A) fuse in the under-hood fuse/relay box or disconnecting the 12 volt battery.