Keyless Access System Registration (2016-17): Procedure

WARNING: This page is about a different car, the 2016 Acura RDX, 2015 Acura RDX, 2014 Acura RDX, and 2013 Acura RDX. However, it is still accessible from the selected car via links, so may be relevant.

Keyless Access System - Register
NOTE:
- Check for aftermarket electrical equipment that could cause problems with keyless access operation.
- While doing the registration, keep the remote away from computers.
- While doing the registration, make sure the doors are closed.
- Programming the remote also programs the keyless transmitter.
- The keyless access/TPMS control unit can store up to 6 remotes.
When Replacing the Keyless Access/TPMS Control Unit or the Electric Steering Lock Control Unit

1. Connect the HDS to the data link connector (DLC)

2. Do the registration according to the instructions on the HDS screen

3. After registration, verify all remote related systems work normally with all remotes.

When Replacing the PCM, MICU, or Registration of the Remote(s)

NOTE: If replacing the keyless access/TPMS control unit, register the keyless access/TPMS control unit first.
1. Connect the HDS to the data link connector (DLC).
2. When replacing the keyless access/TPMS control unit, touch the remote to the engine start/stop switch.
3. When all remotes are lost, select the ON mode according to the instructions on the HDS screen, then go to step 5.
4. Turn the vehicle to the ON mode.
5. Select ONE-PUSH START from the SYSTEM SELECTION MENU, then enter REGISTRATION.
6. Select the appropriate items, and do the registration according to the instructions on the HDS screen.
7. After registration, verify systems work normally with all remotes. If the PCM is replaced, do the procedure after replacing PCM .