VSA Modulator-Control Unit Removal and Installation: Removal

Turn the ignition switch to LOCK (0).
Remove the right engine compartment cover (A) (see ENGINE COMPARTMENT COVER REPLACEMENT ).

Fig 1: Identifying Right Engine Compartment Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the suction line mount bolt (A) from the bracket.

Fig 2: Suction Line Mount Bolt, Receiver Line And Clamp With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the receiver line (B) from the clamp (C).
Disconnect the VSA modulator-control unit 47P connector (A) by pushing the lock (B) and pulling down the lever (C); the connector disconnects itself.

Fig 3: VSA Modulator-Control Unit Components With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the six brake lines from the VSA modulator-control unit.
NOTE: Brake lines are connected to the master cylinder (D) and to the left-front (E), the right-front (F), the left-rear (G), and the right-rear (H) brake systems.
Remove the 6 x 12 mm flange bolts (I) and 6x16 mm flange bolt (J), then remove the VSA modulator-control unit (K) with the bracket (L) from the body.
Remove the receiver line (M) from the bracket, then remove the clips (N).
Remove the VSA modulator-control unit from the bracket.