LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2014 >> TSX V6 >> Repair and Diagnosis >> Brakes >> Traction Control >> VSA System Components (V6) >> VSA Modulator-Control Unit Removal and Installation >> Installation

VSA Modulator-Control Unit Removal and Installation: Installation

  1. Install the VSA modulator-control unit onto the bracket.
  2. Install the clips to the bracket, then install the receiver line.
  3. Install the bracket with the VSA modulator-control unit to the body.
  4. Reconnect the six brake lines, then tighten the flare nuts to the specified torque.
  5. Align the connecting surface of the VSA modulator-control unit 47P connector to the VSA modulator-control unit.
  6. Pull up the lever of the VSA modulator-control unit 47P connector, then confirm the connector is fully seated.
  7. Install the suction line mount bolt to the bracket.
  8. Bleed the brake system (see BRAKE SYSTEM BLEEDING ).
  9. Install the right engine compartment cover (see ENGINE COMPARTMENT COVER REPLACEMENT ).
  10. Do the VSA modulator-control unit update (see VSA MODULATOR-CONTROL UNIT UPDATE  ).
  11. Do the VSA sensor neutral position memorization procedure (see VSA SENSOR NEUTRAL POSITION MEMORIZATION  ).
scientia non olet · About LEMON Manuals