Rear Power Window Switch Test
- Remove the rear power window switch (see REAR POWER WINDOW SWITCH REPLACEMENT
), and disconnect the 14P connector from the switch.
- Test the rear power window switch:
- When the power is connected to terminal No. 2 and ground is connected to terminal No. 14. There should be continuity between terminals No. 8 and No. 1.
- When the power is connected to terminal No. 6 and ground is connected to terminal No. 14. There should be continuity between terminals No. 8 and No. 7.
- When the power is connected to terminal No. 8 and ground is connected to terminal No. 14, then push the rear power window switch to DOWN. There should be continuity between terminals No. 8 and No. 1.
- When the power is connected to terminal No. 8 and ground is connected to terminal No. 14, then pull the rear power window switch to UP. There should be continuity between terminals No. 8 and No. 7.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- If continuity is not as specified, replace the switch (see FRONT PASSENGER'S POWER WINDOW SWITCH REPLACEMENT
).