Transmission Housing Bearing Replacement

Special Tools Required 

• Driver Handle, 15 x 135L 07749-0010000
• Oil Seal Driver, 66 mm 07947-3710200

1. Remove the transfer output shaft bearing (A) from the transmission housing (B) by heating the transmission housing to about 212°F (100°C) with a heat gun (C). Do not heat the transmission housing more than 212°F(100°C).
   Fig 1: Removing Transfer Output Shaft Bearing From Transmission Housing By Heating With Heat Gun

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new bearing in the transmission housing in the direction shown.
   Fig 2: Installing Bearing In Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Drive a new bearing until it bottoms in the transmission housing using the 15 x 135L driver handle and the 66 mm oil seal driver.
   Fig 3: Driving Bearing Until It Bottoms In Transmission Housing Using Driver Handle And Oil Seal Driver

   Courtesy of AMERICAN HONDA MOTOR CO., INC.