Transfer Output Shaft Bearing Replacement

Special Tools Required 

Driver Handle, 40 mm I.D. 07746-0030100

1. Remove the transfer output shaft bearing (A) with a commercially available puller (B), a bearing separator (C), and a spacer (D). Place a spacer between the transfer output shaft and the puller to prevent damaging the transfer output shaft.
   Fig 1: Removing Transfer Output Shaft Bearing With Puller, Bearing Separator And Spacer

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new bearing (A) until it bottoms on the transfer output shaft using the 40 mm I.D. driver handle and a press.
   Fig 2: Installing Bearing Until It Bottoms On Transfer Output Shaft Using Driver Handle And Press

   Courtesy of AMERICAN HONDA MOTOR CO., INC.