LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2013 >> TL Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Side Impact Sensor (First) Replacement >> Removal

Side Impact Sensor (First) Replacement: Removal

  1. Do the battery terminal disconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Remove the B-pillar lower trim (see B-PILLAR UPPER/LOWER TRIM ).
  3. Disconnect the SRS floor wire harness 4P connector (A) from the side impact sensor (first) (B).
    Fig 1: Disconnecting SRS Floor Wire Harness 4P Connector From Side Impact Sensor
    G08068380Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the TORX bolt (C) using a TORX T30 bit, then remove the side impact sensor (first).
scientia non olet · About LEMON Manuals