LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2013 >> TL Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Rear Safing Sensor Replacement >> Removal

Rear Safing Sensor Replacement: Removal

  1. Do the battery terminal disconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Remove the rear seat cushion (see REAR SEAT CUSHION COVER REPLACEMENT ).
  3. Disconnect the SRS floor wire harness 2P connector (A) from the rear safing sensor (B).
    Fig 1: Disconnecting SRS Floor Wire Harness 2P Connector From Rear Safing Sensor
    G08068384Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the TORX bolt (C) using a TORX T30 bit, then remove the rear safing sensor.
scientia non olet · About LEMON Manuals