LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2013 >> TL Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Driver's Seat Position Sensor Replacement >> Removal

Driver's Seat Position Sensor Replacement: Removal

NOTE: Do not turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, while removing the driver's seat position sensor.
  1. Raise the driver's seat all the way up.
  2. Remove the recline cover (see FRONT SEAT RECLINE COVER REMOVAL/INSTALLATION ).
  3. Disconnect the driver's seat wire harness 2P connector (A) from the driver's seat position sensor (B).
    Fig 1: Disconnecting Driver's Seat Wire Harness 2P Connector From Driver's Seat Position Sensor
    G08068392Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the TORX bolt (C) and nut (D) using a TORX T30 bit, then remove the driver's seat position sensor.
scientia non olet · About LEMON Manuals