DTC 44-11: SH-AWD Control Unit
NOTE:
Before you troubleshoot, review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION
).
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
- Clear the DTC with the HDS.
- Turn the ignition switch to LOCK (0), then turn the ignition switch back to ON (II), or select the OFF mode, then the ON mode.
- Check for DTCs with the HDS.
Is DTC 44-11 indicated?
YES - Update the SH-AWD control unit if it does not have the latest software (see SH-AWD® CONTROL UNIT UPDATE ), or substitute a known-good SH-AWD control unit (see SH-AWD® CONTROL UNIT REPLACEMENT ), and recheck. If the symptom/indication goes away with the updated SH-AWD control unit, troubleshooting is complete. If the symptom/indication goes away with a known-good SH-AWD control unit, replace the original SH-AWD control unit (see SH-AWD® CONTROL UNIT REPLACEMENT ).
NO - Intermittent failure, the system is OK at this time.