Gearbox Mount Cushion Replacement

Remove the steering gearbox (see STEERING GEARBOX REMOVAL ).
Position a 34 mm socket (A) on the flange part of the gearbox housing with a washer (B), a 10 x 105 mm flange bolt (C), and a 10 mm nut (D) as shown in illustration.

Fig 1: Identifying Socket On Flange Part Of Gearbox Housing With Washer, Flange Bolt And Nut
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Hold the flange bolt with a wrench, and tighten the nut with a wrench. Remove the gearbox mount cushion (E).
Apply a mild soap and water solution to the new gearbox mount cushion surface (A), then place the mount cushion on the gearbox mounting cushion hole.

Fig 2: Identifying Gearbox Mount Cushion Surface And Socket
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Position a 34 mm socket (B) on the flange part of the gearbox housing with a washer, a flange bolt, and a nut as shown in illustration.
Install the gearbox mount cushion by tightening the nut until the mount cushion edge (A) properly fits on the gearbox flange surface (B).

Fig 3: Identifying Mount Cushion Edge And Gearbox Flange Surface
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the steering gearbox (see STEERING GEARBOX INSTALLATION ).