Side Engine Mount Removal and Installation: Removal
- Remove the passenger's side front fender trim (see
FRONT FENDER TRIM REPLACEMENT
).
- Remove the bracket, then remove the PCM cover (see step 20
).
- Remove the harness clamps and disconnect the PCM connectors and the engine wire harness connector, then remove the PCM (see step 21
).
- Remove the A/C receiver line clamp and the connector from the PCM bracket, then remove the PCM bracket and the harness bracket (see step 22
).
- Lift and support the engine with a jack and a wood block under the oil pan.
- Remove the ground cable bracket (A), then remove the upper half of the side engine mount bracket (B).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Remove the side engine mount (A).
Courtesy of AMERICAN HONDA MOTOR CO., INC.