Rearview Camera Removal/Installation

NOTE:

Remove these items:
- Tailgate trim panel (see TRIM REMOVAL/INSTALLATION - TAILGATE AREA )
- Tailgate lower trim (see TRIM REMOVAL/INSTALLATION - TAILGATE AREA )
- Inner taillights (see INNER TAILLIGHT REPLACEMENT )
Disconnect the rearview camera 16P connector (A), and remove the nuts (B).

Fig 1: Identifying Rearview Camera 16P Connector And Nuts
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pull the rear license trim (A) away from the tailgate, then remove the grommet (B) from the tailgate, and carefully pull the connector through the hole in the tailgate.

Fig 2: Identifying Rear License Trim And Grommet
Courtesy of AMERICAN HONDA MOTOR CO., INC.
From behind the rear license trim, disconnect the connector (A), and remove the self-tapping screws.

Fig 3: Identifying Rearview Camera And Connector With Self-Tapping Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Detach the clips, and remove the rearview camera (B).
Install the rearview camera in the reverse order of removal.