Wiper Motor Test
- Remove the wiper arms (see WIPER MOTOR REPLACEMENT
).
- Remove the cowl cover (see
FRONT BULKHEAD BRACE COVER REPLACEMENT
).
- Disconnect the 4P connector (A) from the windshield wiper motor (B).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Test the motor by connecting battery power to terminal No. 2 and ground to terminal No. 1 of wiper motor 4P connector. The motor should run at low speed.
- Test the motor by connecting battery power to terminal No. 4 and ground to terminal No. 1 of the wiper motor 4P connector. The motor should run at high speed.
- Connect an analog ohmmeter to the terminals No. 3 and No. 1, and run the motor at low or high speed. The needle of the ohmmeter should pulse.
- If the motor does not run or fails to run smoothly, or there is no pulse, replace the motor (see WIPER MOTOR REPLACEMENT
).