Dismounting/Mounting Procedures: Notes
CAUTION:
The tire should be dismounted from the wheel using the tire changer manufacturer's instructions. Use the following information to avoid damage during the dismounting/mounting procedures.
NOTE:
When a tire pressure sensor is replaced or tires are rotated, the sensor ID must be memorized by the TPMS control unit. See RESET PROCEDURES .
NOTE:
Vehicles equipped with TPM system must use wheels made for the system, or system will not work. Use only wheels that have a "TPMS" or "PAX System" mark on them, and a counterweight cast into the opposite side of the spoke to balance the weight of the sensor. See Fig 1.
NOTE:
On models equipped with PAX tire systems, if a tire is repaired or replaced, the warning indicator (and the mileage counter that supports it) must be reset, no matter how far the vehicle was driven in the run flat mode. See PAX SYSTEM RESET under RESET PROCEDURES.