Washer Motor Test

Pull back the front section of the right front inner fender (see FRONT INNER FENDER REPLACEMENT ).
Disconnect the 2P connector (A) from the washer motor (B).

Fig 1: Disconnecting 2P Connector From Washer Motor
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Test the motor by connecting battery power to terminal No. 1 and grounding terminal No. 2 of the washer motor. The motor should run.

If the motor does not run or fails to run smoothly, replace it.
If the motor runs smoothly, but little or no washer fluid is pumped, check for a disconnected or blocked washer hose, or a clogged washer motor outlet.