Forced Starting of the Navigation Unit

Special Tools Required 

SCS Service Connector 07PAZ-001010A

1. Remove the trunk upper trim panel (see TRIM REMOVAL/INSTALLATION - TRUNK AREA ).
2. Turn the ignition switch to LOCK (0).
3. Connect the SCS service connector (A) to the navigation service connector (B) located behind the navigation unit.
   Fig 1: Connecting SCS Service Connector To Navigation Service Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Turn the ignition switch to ON
5. Check that the diagnosis menu for the picture diagnosis starts up, and then changes to the System Links menu.
   NOTE: If the display fails to display the System Links screen, refer to NO PICTURE IS DISPLAYED TROUBLESHOOTING  .