Grab Handle Removal/Installation

Special Tools Required 

KTC trim tool set SOJATP2014 *

* Available through the Acura Tool and Equipment Program, call 888-424-6857

1. Lower the grab handle (A), then insert a small flat-tip screwdriver wrapped in protective tape into the notch
   Fig 1: Inserting Small Flat-Tip Screwdriver Wrapped In Protective Tape Into Notch

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Use a KTC trim tool (A) to pull on the small flat-tip screwdriver, and remove the cap (B)
   Fig 2: Removing Cap

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Pinch the clips (A) to release the hooks (B), then remove the grab handle (C)
   Fig 3: Removing Grab Handle

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the clips (A) by pinching the hooks with a pair of pliers
   Fig 4: Removing Clips

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. If the side curtain airbag has deployed, replace the grab handle with a new one
6. If the side curtain airbag has not deployed, inspect the grab handle for damage A damaged grab handle may cause the side curtain airbag to deploy improperly, possibly causing injury Replace the grab handle if it has any of the following damage
   • Any cracks or damage in the grab handle (A)
   • Any cracks or stress-whitening in the caps (B)
   Fig 5: Identifying Grab Handle And Caps

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Install the clips (A) on the grab handle (B), then insert the caps (C) fully into the clips
   Fig 6: Identifying Clips On Grab Handle

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
8. Position the grab handle (A) on the mounting bracket (B), and push on the grab handle until the clips (C) snap into place securely
Fig 7: Positioning Grab Handle On Mounting Bracket
Courtesy of AMERICAN HONDA MOTOR CO., INC.