Selector Control Shaft Bearing Replacement

Special Tools Required 

• Remover shaft 07936-GE0A000
• Sliding hammer weight 07936-371020A
• Driver handle, 15 x 135L 07749-0010000
• Attachment, 22 x 24 mm 07746-001A800

1. Remove the control shaft bearing from the transmission housing using the remover head the remover shaft and the sliding hammer weight
   Fig 1: Removing Control Shaft Bearing From Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new bearing in the transmission housing using the driver handle and the 22 x 24 mm attachment
   Fig 2: Installing Bearing In Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.