LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2011 >> TL Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Clutch System) >> Slave Cylinder Replacement >> O-ring Replacement

O-ring Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Remove the slave cylinder.
  2. Remove the roll pins (A), then remove the clutch line connector (B) and the O-ring (C) from the slave cylinder (D).
    Fig 1: Removing Roll Pins
    G06679779Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the clutch line connector (A) with a new O-ring (B), then set in new roll pins (C) to the slave cylinder (D).
    Fig 2: Setting Roll Pins To Slave Cylinder
    G06679780Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the slave cylinder.
scientia non olet · About LEMON Manuals