Oil Pump Overhaul: Installation
- Remove the old oil seal from the oil pump
- Dry the crankshaft oil seal housing
- Using the oil seal driver, 64 mm, drive in the new crankshaft oil seal until the oil seal driver bottoms on the pump
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Remove all of the old liquid gasket from the oil pump mating surfaces, the bolts, and the bolt holes
- Clean and dry the oil pump mating surfaces
- Apply liquid gasket, P/N 08717-0004, 08718-0003, or 08718-0009 to the engine block mating surface of the oil pump and to the inside edge of the threaded bolt holes Install the component within 5 minutes of applying the liquid gasket
NOTE:
- Apply a 2.3 mm (0.091 in) diameter bead of liquid gasket along the broken line (A)
- If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes
- If too much time has passed after applying the liquid gasket, remove all of the old liquid gasket and residue, then reapply the new liquid gasket
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Apply a light coat of new engine oil to the lip of the crankshaft oil seal, and apply new engine oil to the new O-ring (A)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Install the dowel pins (B), then align the inner rotor with the crankshaft, and install the oil pump (C)
NOTE:
- Wait at least 30 minutes before filling the engine with oil
- Do not run the engine for at least 3 hours after installing the oil pump
- Clean the excess grease off the crankshaft, and check the seal for distortion
- Install the oil strainer (D) with a new O-ring (E)
- Install the oil pan (see
OIL PAN INSTALLATION
)
- Install the rocker arm oil control solenoid/oil filter assembly with a new rocker arm oil control solenoid filter (see step 39 on
CKP PULSE PLATE REPLACEMENT
)
- Install the timing belt drive pulley to the crankshaft
- Install the timing belt
- Remove the chain hoist.