Trunk Lid Spoiler Switch Test/Replacement

Open the trunk lid, and remove the trunk lid spoiler (see TRUNK LID SPOILER REPLACEMENT )
Disconnect the 2P connector (A) from the rearview harness (B)

Fig 1: Identifying Rearview Harness, Trunk Lid Spoiler Switch And 2P Connector Terminals With Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the three screws, and the trunk lid spoiler switch (C)
Check for continuity between terminals No l and No 2
- With the switch pushed, there should be continuity
- With the switch released, there should be no continuity
If the continuity is not as specified, replace the switch
Install the switch in the reverse order of removal