Trunk Lid Opener Main Switch Test/Replacement

Remove the glove box housing (see GLOVE BOX REMOVAL/INSTALLATION )
Carefully push the main switch (A) out from behind the glove box housing

Fig 1: Identifying Main Switch And 2P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the 2P connector (B) from the trunk lid opener main switch
Check for continuity between terminals No l and No 2
- With the main switch ON, there should be continuity
- With the main switch OFF, there should be no continuity
If the continuity is not as specified, replace the main switch
Install the switch in the reverse order of removal