Selector Control Shaft Bearing Replacement

Special Tools Required 

• Bearing Remover Shaft Set, 15 mm 07936-KC10500
• Slide Hammer 07936-371020A
• Driver Handle, 15 x 135L 07749-0010000
• Bearing Driver Attachment, 28x30 mm 07946-1870100

1. Remove the selector control shaft bearing from the transmission housing using the bearing remover shaft set and the slide hammer.
   Fig 1: Removing Selector Control Shaft Bearing From Transmission Housing Using Bearing Remover Shaft Set And Slide Hammer

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new bearing until it bottoms in the transmission housing using the driver handle and the bearing driver attachment.
   Fig 2: Installing Bearing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.