LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2011 >> RDX 2.3 TB2 >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System >> Starter Performance Test

Starter Performance Test

  1. Remove the starter (see STARTER REMOVAL AND INSTALLATION  ).
  2. Clamp the starter firmly in a vise.
  3. Make the connection for this test using the thickest (gauge) wire possible (preferably the same gauge as used on the vehicle).
    NOTE: To avoid damaging the starter, never leave the battery connected for more than 5 seconds.
    Fig 1: Checking Continuity Between B Terminal And Starter Body With Battery Connected
    G08072566Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Connect the battery as shown in illustration, and check for continuity between the B terminal and the starter body. If there is continuity, it is working properly.
  5. Disconnect the battery from the body, and check for continuity between the B terminal and the starter body. If there is no continuity, it is working properly.
    Fig 2: Checking Continuity Between B Terminal And Starter Body (Battery Disconnected)
    G08072567Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Connect the starter to the battery as shown in illustration, and confirm that the motor runs.
    Fig 3: Connecting Starter To Battery
    G08072568Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. If the electric current meets the specification when the battery voltage is at 11.5 V, the starter is working properly.

    Specification 

    Electric Current: 80 A or less 

scientia non olet · About LEMON Manuals