Driver's Power Window Motor Test

Motor Test 

1. Remove the power window master switch (see POWER WINDOW SWITCH REPLACEMENT  ), and disconnect the connector (A).
   Fig 1: Identifying Power Window Master Switch Connector End View

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Test the motor in each direction by connecting battery power and ground to the power window master switch 22P connector according to the table.
   Fig 2: Power Window Master Switch 22P Connector Terminals Continuity Chart

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. If the motor does not run or fails to run smoothly, go to step 4. If the motor is OK, do the power window master switch input test (see POWER WINDOW MASTER SWITCH INPUT TEST  ).
4. Disconnect the 6P connector from the driver's power window motor.
5. Check for continuity between power window master switch 22P connector terminals No. 20 and No. 21 and driver's power window motor 6P connector terminals No. 1 and No. 4 respectively.

   POWER WINDOW MASTER SWITCH 22P CONNECTOR 

   terminal No. 20 

   terminal No. 21 

   DRIVERS POWER WINDOW MOTOR 6P CONNECTOR 

   terminal No. 1 

   terminal No. 4 

   Fig 3: Checking Continuity Between Power Window Master Switch 22P Connector Terminals 20 And Driver's Power Window Motor 6P Connector Terminals 1

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. If the wire harness is OK, replace the driver's power window motor (see FRONT DOOR GLASS AND REGULATOR REPLACEMENT ).

   Pulser Test 

7. Do the power window master switch input test at terminals No. 5, No. 6, No. 7, and No. 11 (see POWER WINDOW MASTER SWITCH INPUT TEST  ).