LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2010 >> RL >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Starter Solenoid Test

Starter Solenoid Test

  1. Do the battery terminal disconnection procedure (see DISCONNECTION ).
  2. Remove the harness clamp (A), starter cable (B), and the motor cable (C), and disconnect BLK/WHT wire connector (D).
    Fig 1: Harness Clamp, Starter Cable, Motor Cable & BLK/WHT Wire Connector With Torque Specifications
    G06163190Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). There should be continuity.
    • If there is continuity, go to step  4.
    • If there is no continuity, replace the solenoid.
  4. Check the pull-in coil for continuity between the S terminal and the M terminal. There should be continuity.
    • If there is continuity, the solenoid is OK.
    • If there is no continuity, replace the solenoid.
  5. Install wire and the connector in the reverse order of removal.
  6. Do the battery terminal reconnection procedure (see RECONNECTION ).
scientia non olet · About LEMON Manuals